Outstation 4x4 Get launch news

Wireless dash switches.

No cable run to the box.

Switches made for the spare blanks in your dash. Each one takes 12 V+ and earth from nearby and reports to the control box by radio.

Get launch news

Press a blank to clip a switch in. Press a switch to turn it on.

Every switch reports in.

A 4x4 wagon seen from the side A switch in the dash at the front and a control box in the rear cargo area. The switch has two short wires at the dash. No cable joins the switch and the box.
  1. The usual way

    Most switch systems run a loom from the dash back to the relays.

  2. Two wires at the dash

    An Outstation switch takes 12 V+ and earth from nearby. Nothing runs to the back.

  3. Press

    The switch reports to the control box by radio.

  4. The box does the work

    It switches the output: light bar, compressor, fridge.

  5. The light tells the truth

    The box reports back, and only then does the indicator on the switch come on.

How it goes in

Power and earth at the blank. Nothing to run back.

  1. Clip it in

    Each switch clips into a spare 22 × 22 mm blank. Its own small module sits behind the dash on the switch’s wiring tail.

  2. Power and earth

    The module takes 12 V+ and earth from nearby, through one fused tap shared by all the switches. That is all the wiring at the dash.

  3. Pair it

    Pair the switch to the control box in the app and choose the output it runs. The setting is stored in the box, so it works with no phone in the car.

Three ways to work

Pick a way, then press the switch. The light only comes on when the box says the output is on.

Control box, eight outputs

Light bar on output 1: off.

Sixteen icons so far. Pick one for the switch.

What it will not do

A quiet switch can’t leave an output stuck on. If a switch stops reporting, momentary outputs turn off and the rest follow the rule you set.

The light tells the truth. It shows what the control box reports, not what the switch assumes.

Settings live in the box, not the phone. Set it up once in the app. It works with no phone in the car.

Why Outstation

An outstation is a remote post that reports to the main station. On the old telegraph lines every one of them was joined to the next by wire. Each of our switches is an outstation too: it sits in its own blank and reports to the box in the rear, with no line between them.

  • A long low stone building on a bare rise
    Charlotte Waters telegraph station, about 1900
  • A long bench of telegraph instruments under a clock
    The operating room at Eucla, early 1900s
  • White buildings and stock yards below the ranges
    Alice Springs telegraph station, about 1900
  • A lone telegraph pole standing in long grass on red earth
    A pole of the old telegraph line, still standing
  • A telegraph station seen from the hill behind it, with plains to the horizon
    Barrow Creek telegraph station, about 1900
A red dirt road in outback Australia, corrugated by traffic, running straight to the horizon

Designed for corrugations.

A latching connector and a tie-down point on every module.

Starting with the Prado 250

The first kit is made to suit the Toyota Prado 250 and its square 22 × 22 mm blanks. We are measuring a real blank and sample switches before we promise a fit. More popular 4x4s follow once each one is checked.

Tell me when it is ready
Register for launch news. This opens an email to us; send it and we will write once, when the kit is ready to order. Register